Khuôn Squishy Narwhal!

This is a Squishy mold kit of a classic Narwhal.  The mold is a split mold that can be held together with 2 binder clips and a little scotch tape. I notched the mold out to reduce material, as well.

I recommend using Elmer's squishy mix, but any silicone casting resin will work just as well.  The resin takes about an hour to set.

For best finish, I recommend painting on surface texture across the surface of the narwhal in the mold.  Use a finer setting to hide the layer lines. .2mm layer height works fine, and the details turn out visible.

Scale up or down to your liking.  A scale of about 150-165% will use the full 2-part Elmer's mix.  

While the original model this was derived from was AI created, this mold model was not.