Đế/giá đỡ Braun Thermoscan 7 và probe covers

This is a base for the Braun Thermoscan 7 and probe covers.  This is intended to be filled with sand or salt after printing to give the base some extra weight.

Print Recommendations

• I printed these in PETG with a 0.4mm nozzle, and filled the base after printing with salt to add weight.

• If you plan to add weight I recommend adding a small cylindrical print modifier in Prusa slicer at the fill port in the base and setting the perimiters, top, bottom, infill etc all to zero so that you'll have an opening into the infill.

• Infill: 5% gyroid (if planning to fill with sand/salt)

• Top layers: 5 or 6 to make up for the sparse infill if planning to fill with sand/salt.

• A small plug is included that can be glued in after filling