
Kiếm Spartan – Lấy cảm hứng từ phim 300
- Downloads
- 6
- Likes
- 3
- Views
- 113
- Remixes
- 0
- Comments
- 0
Files 7 4.1 MB
- Rear_blade_1771899779.stlSTL · 29.9 KB
- Front_blade_1771899780.stlSTL · 50.2 KB
- Grip_no_leather_1771899781.stlSTL · 587.5 KB
- Grip_1771899782.stlSTL · 520 KB
Make a variant with AI
Build another version of this model.
Details
- Model ID
- #225170
- Category
- Cosplay
- Published
Description
300 Movie-Inspired Spartan Sword (Leonid's Sword)
This design, inspired by the sword from 300: Battle of Thermopylae, has been optimized for 3D printing and easy post-processing.
Printing recommendations:
For Bambu Studio users, use the provided profile for optimal results. Otherwise, follow the part orientation shown in the image.
-
Use glue stick for improved bed adhesion.
-
Utilize supports and rafts as needed.
-
Print with 3 perimeters for enhanced durability.
-
PLA is recommended for easy post-processing.
-
Two grip versions are available: "grip" for leather straps and "grip no leather" (larger) for use without leather straps.
Hardware (for best look):
-
2x M3x20 or M3x25 mm screws.
-
2mm thick leather straps.
-
Superglue
-
Putty
-
Sand paper
-
Primer spray
-
Spray paint
Assembly:
-
Sand all parts for a smooth finish.
-
Dry-fit the grip and handguards, then disassemble.
-
Apply thin double-sided tape to both sides of the grip, leaving a 1cm border.
-
Wrap leather straps, securing ends with super glue and trimming flush with the grip's edge.
-
Glue the blade sections together and fill seams with putty. Sand smooth. Mask 1 cm of the blade's base for gluing to the handguard.
-
Prime all parts except the grip.
-
Paint to your desired color.
-
Attach the "front handguard" to the grip with two M3x25mm screws and super glue. Secure the "rear handguard" with super glue.
-
Glue the blade to the handguard.
-
Enjoy your finished sword!
Print spec
- Formats
- 3mfstl
- Model files
- 7
- Total size
- 4.1 MB
- Largest file
- 1.1 MB












