
Core One/+/L Side Pocket Edge Cover – Nắp che mép hộc bên
- Downloads
- 3
- Likes
- 1
- Views
- 95
- Remixes
- 0
- Comments
- 0
Files 2 35.1 KB
- CoreOneSidePocketEdgeCover_Left_1771903804.stlSTL · 17.9 KB
- CoreOneSidePocketEdgeCover_Right_1771903805.stlSTL · 17.3 KB
Make a variant with AI
Build another version of this model.
Details
- Model ID
- #225040
- Category
- Máy In 3D
- Published
- License
- Creative Commons — Attribution
Description
Sealing the gaps in the enclosure of the Core One/+/L can help reduce heat loss when printing materials that require a higher chamber temperature (ASA, ABS, etc.). These models helps to seal the gaps in the side pockets created by the bend sheet metal.
I've only tested these on my Core One +, but the side pockets of the Core One L should be identical.
Materials & Print Settings
It's important to print these in PETG or another material that can withstand higher temperatures!
You'll need 2x of the Right & Left model. Prints without supports, flipped outside down (see 3rd photo).
These are the print settings I used:
- Filament: Galaxy Black PETG
- Nozzle: 0.4mm brass HF
- Layer height: 0.2mm
- Infill: 15% adaptive cubic
You'll need 1x Ø10x2mm magnet for each cover. The small pin at the back of the model will fit through the small hole in the pocket, acting as an installation guide and holds the cover in place (and thereby reduces the magnets needed). I can upload models with space for two magnets (and without the pin if needed).
Print spec
- Formats
- stl
- Model files
- 2
- Total size
- 35.1 KB
- Largest file
- 17.9 KB
0 comments
You may also like 12 models
See all-

-

-

-

-

-
New -
New -
New -

-

-

-


