Offset cảm biến filament Elegoo Centauri Carbon

This filament sensor offset holder is the maximum the factory cable allows. You will need to open the wire loom inside the main chamber and snip the 2 wire ties. It is enough to gain that little extra bit of length. You will need to replace the screw that attaches the holder to the side panel with a longer version, 8mm works for me.

I required the maximum amount of height adjustment and offset due to accommodate the Creality filament drier I am using.

There are 2 copies of this model, minimal and strong. In the minimal model the diagonal support is half the width of the piece, in the strong model it is the full width. I am just paranoid about this part breaking so it is very much overengineered.