Snapmaker U1 Slim SAMLA Hat (By Muts)

By Muts_307410

Downloads: 16
Likes: 11
Views: 193
Remixes: 0
Comments: 0

Download all (.zip)· 15 files · 5.7 MB· 5.7 MB

Files 15 5.7 MB

Muts_Hat_open_in_Snorca_1771117893.3mf3MF · 914 KB
Muts_Hat_-_front_left_1771117895.stlSTL · 996.1 KB
Muts_Hat_-_front_right_1771117895.stlSTL · 941.9 KB
Muts_Hat_-_mid_left_1771117896.stlSTL · 129 KB
Muts_Hat_-_mid_right_1771117896.stlSTL · 141.5 KB
Muts_Hat_-_rear_left_1771117897.stlSTL · 565.3 KB

Make a variant with AI

Build another version of this model.

Open Studio

Details

Model ID: #220759
Category: Máy In 3D
Published: 02/15/2026
License: Creative Commons — Attribution — Noncommercial — Share Alike
Tags: cover
hat
snapmaker
u1
snapmakeru1
tophat

Show more tags Show fewer tags

Description

The standard SAMLA Hat by Beaverworks wasn't quite what I wanted so I made my own!

This version sits flush (or as close as I could get it) with the top of the U1, It therefore also doesn't cover any of the sides. It also comes with half the pieces and can almost be printed with just one of the included spools (550g). Everythhing fits on 3 plates and can be printed in about 12.5 hours.

There are some tweaks that I've implemented after printing my own test version. Those changes are untested since I didn't fancy wasting 500g on something I'll never use.

There was an attempt to modify Beaverworks' model, but I quickly found out it'd be way simpler to start from scratch. If there's any issues, comment or contact me on Discord, details on the bottom of the hat :)

You'll ofcourse also need a SAMLA.