Chậu Bonsai Stillwater – Insert Tự Tưới (Self-Watering)

Bonsai Pot – Self-Watering Insert Planter is a low, calm bonsai bowl with the signature Stillwater ripple texture—made to look soft and ceramic-like, but printed clean and sturdy. It’s a 2-part system: the outer pot holds the water reservoir, and the insert keeps the bonsai medium lifted and evenly fed through capillary action (wick/medium contact), so the roots don’t sit in water.

Works great for indoor bonsai setups where you want stable moisture + less daily checking, while keeping that minimal, smooth interior and the textured exterior as the main visual.

(Tip: best results with a bonsai soil mix that can wick well; avoid keeping the reservoir permanently full for sensitive species.)

Print Settings

Global (Outer Pot + Insert)

• Wall generator: Arachne

• Outer wall line width: 0.6 mm

• Inner wall line width: 0.6 mm

Outer Pot (Bonsai Bowl)

• Wall loops: 4

• Bottom shell layers: 8

Modifiers

1. Range modifier (Z: 0 – 1.6 mm)

   • Wall loops: 2
     (Keeps the very bottom clean and reduces over-thick stacking where it’s not needed.)

2. Range modifier (Z: 62.80 – 63.00 mm)

   • Top surface pattern: Concentric
     (Gives that clean “waterline” finish on the top lip / rim surface.)

Insert (Self-Watering Insert)

• Seam position: Back

Modifier

• Range modifier (Z: 0 – 2.60 mm)

  • Wall loops: 2

  • Bottom shell layers: 9
    (Strengthens the insert base and keeps it solid where it takes the most load.)