Hộp đựng thẻ SD || MicroSD (Card Case)

| BASIC DESCRIPTION |

• it is a remix of a model found here: 

https://www.printables.com/model/20415-sdmicrosd-card-case

https://www.printables.com/model/23326-sdmicrosd-card-case-snap-fit

• this remix has 8 slots for microSD, and one for the adapter (or a full sized SD card)

| DESIGN DECISIONS |

• it was also completely remodeled from ground up because I have found that the two previous models had much tighter tolerances on the micro SD cards than I wanted it to have, so I made mine a little wider and with an additional cut out so the microSD cards can be slid out easier
• I really liked the snap fit on the remix so I incorporated it in my remix too
• also, I wanted to make it smaller and to pack as much as microSD cards as possible in this form factor, and only one adapter - I always only need one when I am on the road

| PRINT SETTINGS |

• General notions:

  • no supports required

• The settings that I used:

  • Resolution: 0.15 mm
  • Infill: 20%
  • Filament: PETG