X-Shot Longshot Barrel Collet V2 SHORT

I very much liked RedCowls model, however there was not enough room at the end of my barrel to attach any muzzle devices. So I took the corrected champfer version of the model into blender and noticed internal geometry and other excess geometry. I cleaned that up, then I shortened the piece by 5.5mm. I may upload an even shorter version as there is still plenty of space to close up. I then took the collet and replaced the knurled bit with my own design and included enough space for a lot of friction fit muzzle devices to fit down into the collet some what. This took 6.5mm off of the collet for a total of 12mm extra space on the barrel. As with the originals, please print these in the orientation they are saved in, I recommend PET-G for maximum strength, and enough walls and fill for how rough you play. Also, OOD, I don't mind if you add this to your listing.