Skip to main content
F3D
Shell scratcher – Bàn chải gãi mai cho rùa 1

3 images

Đồ Gia Dụng

Shell scratcher – Bàn chải gãi mai cho rùa

Remix of Crumb Sweeper – Dụng cụ quét vụn trên bàn (in 3D) By LoboCNC

By ht_2280624

Downloads
2
Likes
1
Views
84

Files 5 9.8 MB

  • Mount_1770848592.stlSTL · 552.8 KB
  • Shear_tool_1770848593.stlSTL · 164.5 KB
  • Centre_spindle_1770848594.stlSTL · 70.4 KB
  • Tortoise_brush_1770848595.3mf3MF · 1.6 MB

Make a variant with AI

Build another version of this model.

Open Studio

Description

Inspired by the cow scratchers you see in the cattle barn.

2 rotating brushes around a centre spindle giving your tort full control of his scratching.

The centre spindle needs to be strong because torts are stronger than you'd expect (don't ask me how I know).

  • 0.2 layer height.

  • Use 5 walls with 90% gyroid infill for the centre spindle. This seems a lot I know but trust me on this.

  • Use 3 walls with 30% gyroid infill for the mount. 

  • Use random seam for the brushes, for everything else, scarf seams work well. 

Assembly

  • After printing, press the shear tool into the end of the brush support tube. Don't twist it - just press it slowly all the way down the length of the brush until all the bristles have been sheared off. It may help to tap the end of the shear tool with a small mallet.

  • Slide the brushes over the spindle. They should spin freely.

  • Put some CA glue into the hole in the mount and slide the end of the spindle into the hole and allow to cure (be careful not to get glue under the brushes else they will stick too).

  • Mount in your desired location.

Read more Show less

Print spec

Formats
3mfstl
Model files
5
Total size
9.8 MB
Largest file
7.4 MB

0 comments

See all