Sửa lỗi cho Moccamaster

My Moccamaster always had a problem with the drop stop, the coffee always runs along the drop stop lever and on to the lid of the coffee pot. First cup always resulted in coffee on the table and the coffee continue to drive from the lever on to the heater.

After having my Moccamaster Technivorm Clubline för two years, i decided to fix this.

The mechanics for the drop stop is faulty from the factory and the drop stop only opens about one Millimeter when the pot is on the heater and the lever gets an angle that the cofee can run on the lever. My fix adds 3mm lift on the end of the lever. No more coffee on the table!

Print Settings

Printer:

Geeetech Prusa i3

Rafts:

Doesn't Matter

Supports:

Doesn't Matter

Resolution:

0.1mm

Infill:

doesn't matter

Notes:

Turn it upside down for easier printing,
Scale it up 0.5% if it doesnt fit, and print it again.

Category: Kitchen & Dining