
Cable Hero - Cuộn cuốn cáp Print-in-Place “xịn” nhất
- Downloads
- 850
- Likes
- 275
- Views
- 3,298
- Remixes
- 0
- Comments
- 0
Files 15 86.7 MB
- Cable_Hero_Blank_L_1770536930.stlSTL · 3.6 MB
- Cable_Hero_Knurled_L_1770536930.stlSTL · 5 MB
- Cable_Hero_Hex_L_1770536931.stlSTL · 4.4 MB
- Cable_Hero_Waves_L_1770536932.stlSTL · 5.6 MB
Make a variant with AI
Build another version of this model.
Details
- Model ID
- #212446
- Category
- Đồ Gia Dụng
- Published
Description
Cable Hero - The Ultimate Print-in-Place Cable Reel ⚡
Say goodbye to tangled wires and messy desks. The Cable Hero is here to save your cable management game! This is a fully Print-in-Place design, meaning the rotating mechanism prints fully assembled. No screws, no glue, and no snapping parts together—just print and wind.
Designed specifically for USB-C cables, this reel comes in three sizes and five distinct textures to match your style.
📏 Sizing Guide:
Choose the right size based on your cable length and thickness.
Size
Dimension
Capacity / Cable Fit
Small
68 x 25 mm
Best for 3-4mm thick cables up to 1m length.
Medium
75 x 28 mm
Fits standard USB-C cables up to 1.5m length.
Large
81 x 30 mm
Fits long cables up to 1.7m. Accommodates USB-C and smaller USB connector heads.
🎨 5 Styles Available
I have included five different finishes so you can choose the grip and look that suits you best:
-
Waves: A flowing, organic texture.
-
Hex: A technical, geometric honeycomb look.
-
Knurled: High-grip texture, perfect for easy winding.
-
Ripples: A concentric water-drop effect.
-
Blank: Smooth and clean minimalist look.
⚙ How to Use
-
Insert: Push one end of your cable all the way through the center hole of the reel until the connector sticks out the other side.
-
Center: Position the reel roughly in the middle of the cable (or wherever you prefer).
-
Wind: Hold the outer ring and rotate the inner mechanism to wind the cable inside until you reach your desired length.
🖨 Print Settings
-
Supports: ⛔ NO SUPPORTS
-
Material: PLA, PETG, or ABS.
-
Infill: 15% - 20% usually works great.
-
Walls/Perimeters: 3 walls recommended for strength.
-
Brim: Use brim if you experince adhesion issues with outer ring
-
Clearance: This is a Print-in-Place design with tight tolerances. Ensure your printer is calibrated. If the mechanism is stiff right off the bed, give it a firm twist to "break" the internal adhesion, and it will spin freely.
Happy Printing! If you like the Cable Hero, please leave a like and post a picture of your make!
Print spec
- Formats
- stl
- Model files
- 15
- Total size
- 86.7 MB
- Largest file
- 10.2 MB
0 comments
You may also like 12 models
See all-
New -

-

-

-

-
New -

-
New -

-

-
New -
New

