Kệ để Socket nghiêng SAE & MM (Slanted Socket Rack SAE and MM)

*** SEE Edit Below ***

I wanted something different from designs I have seen to hold my sockets in my toolbox. So I made this slanted socket rack. It fits nicely in the shallow drawers of my toolbox. And the slanted design makes it easy to see and get the sockets off.

I also have a SAE version.

If time allows I am going to make one for 3/4 and 1/4 drive sockets.

I had to print in 2 pieces since my print bed is small. I put 2 3/8" holes to allow for dowels to put the 2 sides together.

If you like my design please leave a comment and like my designs.

*** EDIT ***

I have added the SAE version. It lays down a bit more for the deep sockets. And the regular sockets stand up a little straighter. The Socket Rack MM version 2 matches the SAE version as it lays down farther for the deep sockets and the regular sockets stand up straighter

• Notes:

  Each side uses about 215g
  Takes about 16 hours per side to print
  .2mm
  PLA
  15% infill
  Tree supports