
Skirts Voron 2.4 hex infill (250/300/350mm)
- Downloads
- 1,703
- Likes
- 285
- Views
- 7,629
- Remixes
- 2
- Comments
- 0
Files 31 50.3 MB
- SkirtA_1770337433.stlSTL · 792.4 KB
- SkirtB_1770337434.stlSTL · 791.9 KB
- 2.4R1_Side_Set_With_Mesh_1770337435.stlSTL · 1.5 MB
- 350_Side_A_1770337436.stlSTL · 1.5 MB
Make a variant with AI
Build another version of this model.
Remix versions 2
Công tắc nguồn mặt trước 350ByAxelKoeneke_2195901 · 02/06/2026
Đầu Nối Nguồn Bên Hông 350 (350 Side Power Connector)ByAxelKoeneke_2195901 · 02/06/2026
Details
- Model ID
- #212005
- Category
- Máy In 3D
- Published
- License
- GNU General Public License v3.0
Description
I remixed the default Voron 2.4 skirts, adding a hex pattern inside the original hex.
I also remixed the fan mount skirt, adding the same hex pattern and reworking it to be mounted backwards. The backwards mounting was necessary to allow the hex infill to print without a bunch of supports. I also added an outward facing Voron logo.
The backwards mounting method will require 3 additional heat set inserts per fan. The fans will need to be mounted with with 3 screws from the inside, and the fan grills mounted with the original threaded inserts.
To do multicolor prints with these models, you will need to swap filament at the appropriate layer.
The 6020 fan blank allows you to keep the same look on each side, without having to install additional fans.
I created a fan grill specifically for the backwards fan support mod, in a seperate listing.
Print spec
- Formats
- stlstp
- Model files
- 31
- Total size
- 50.3 MB
- Largest file
- 2.8 MB
0 comments
You may also like 12 models
See all-

-

-
New -
New -
New -
New -

-

-

-

-

-


