Cúp in 3D: Ra khỏi dây tóc

Another in my series for makers to earn achievements for their dedication to 3D printing.

Model prints with no supports and with 10% infill.  Optional panels are included if you want to print brown/wood covers for the model base.

This trophy is earned when your print doesn't quite finish because you ran out of filament, but your 3d printer doesn't seem to notice. Maybe you should keep a spreadsheet or something.

Note: Keeping with the spirit of my trophies, rather than pull the filament to make the Octolapse, I edited the Gcode to remove extrude commands after a certain point, then manually added the OctoLapse capture commands.

I have included the following:

• Cut Model that can simply be sliced and used
  • Ran out of filament.stl
• Full Model that can be cut however you like
  • Ran out of Filament_Full_cutat112.4mm.stl
• Edited GCode for Ender 3 Pro*
  • CE3PRO_Ran out of Filament_GcodeCut.gcode

*Warning: Use GCode file at your own risk. I take no responsibility for whether the GCode is compatible with your printer.

Special thanks toFormerLurkerfor helping me with the GCode edit for OctoLapse.