Thùng purge Elegoo Centauri Carbon - Không support, kèm nam châm

I liked the fully closed purge bin designed by MikeyLew32 but modified it to be printable with no support and include four 3x6 mm (standard voron size) magnets to keep the drawer in place and minimize rattling during printing. Magnets could be excluded if you don't have them.

The bottom mounting hole has also been split into a separate mounting bracket which is secured with M3 screws. This design has them go into heatset inserts in the housing, 3 mm long, shorter than the typical size! If you don't have them you could opt to make these holes smaller and screw directly into the plastic.

Hardware:

3x M3x6 screws

2x m3 x 3mm length heatset insert

4x 6x3 mm magnets 

REVISED 6/11/25:
as suggested by @airtonzanon I have added modified mount and housing files that do not use heatsets. Instead an M3 countersunk screw is screwed in from above and an m3 nut goes below the mount to secure it.