Skip to main content
F3D
Snapmaker U1 Easy Spool Holder… 1

5 images

Máy In 3D

Snapmaker U1 Easy Spool Holder (Bản thay thế gắn/tháo cuộn dễ hơn)

By JohnS

Downloads
40
Likes
15
Views
349
Remixes
1

Files 13 2.4 MB

  • U1_spool_holder_1_1770091836.stlSTL · 247.3 KB
  • u1_spool_holders_1770091836.3mf3MF · 374.1 KB
  • U1_spool_holder_1770091837.stlSTL · 243.5 KB
  • U1_spool_holder_4_1770091838.stlSTL · 246.3 KB

Make a variant with AI

Build another version of this model.

Open Studio

Remix versions 1

See all 1 remix

Details

Model ID
#210130
Category
Máy In 3D
Published

Description

The original spool holders are a bit difficult to take a lot of spools on and off. I think they did it that way so RFID spools would stay nice and close to the reader, but if you are like me and not using that much Snapmaker filament so far, then they are just a pain.  These print without supports and snap on in place of the originals.  Another improvement is that the holders are also much easier to remove without feeling like you are going to break your side panel.  To remove them, first rotate them a bit past 90 degrees to disengage the latches and they come out fairly easy.  I went through several iterations to get the attachment just right.

They were designed and tested with PETG in mind.  The snaps work well with PETG and I have not tried it with any other filament. Likely, would be just fine in PLA.

I included step files and the Fusion file so you can adjust to your needs.

I suggest having enough wall thickness in the snap area so that prints solid.

Read more Show less

Print spec

Formats
3mff3dstepstl
Model files
13
Total size
2.4 MB
Largest file
374.1 KB

0 comments

See all