Skip to main content
F3D
Stand xoay cho Shelly Wall Display XL 1

8 images

DIY

Stand xoay cho Shelly Wall Display XL

By Ronnikn_195531

Downloads
1
Views
113

Files 3 1 MB

  • WDXL_rotate_stand_1770085038.stlSTL · 768.3 KB
  • WDXL_rotate_attachmant_ring_1770085038.stlSTL · 221.6 KB
  • Strainrelief_1770085040.stlSTL · 41.5 KB

Make a variant with AI

Build another version of this model.

Open Studio

Description

A stand that allows you to rotate a wall display 90 degrees, from horizontal to vertical orientation.

Printed with supports. It may not print successfully without them.

The stand consists of three parts:

  1. The main stand

  2. The attachment ring

  3. The strain relief for the cable (optional)


How to Assemble

  1. Slide the attachment ring into the stand with the corner pointing downward.

  2. Push the ring into place until it slides/clicks in, with the arrow pointing upward.

  3. Feed the cable into the stand from the back and route it out through the attachment ring.

  4. Mount the cable to the wall display backplate.

  5. Use the strain relief to secure the cable and ensure it is properly tightened.

  6. Carefully slide the wall display into the attachment ring to prevent it from falling out.
    (It may help to press gently on each side of the stand.)

  7. Tighten the backplate to the stand while it is in the horizontal position.

  8. Screw the backplate securely to the stand

  9. Rotate the wall display 90 degrees back and forth as needed.

Note:
When rotating the display, make sure to press the wall display slightly upward

Note 2: User rubber feet's to get the best experience :)

Read more Show less

Print spec

Formats
stl
Model files
3
Total size
1 MB
Largest file
768.3 KB

0 comments

See all