
Máy In 3D
Giá đỡ camera Wyze v3 (+pro) cho AnkerMake M5
- Downloads
- 505
- Likes
- 102
- Views
- 3,193
- Remixes
- 1
- Comments
- 0
Files 1 268.6 KB
- LeftWyzeCamv3Mount_nosupport_printable_R3_1766233540.stlSTL · 268.6 KB
Make a variant with AI
Build another version of this model.
Remix versions 1
See all 1 remixDetails
- Model ID
- #20931
- Category
- Máy In 3D
- Published
Description
The built-in m5 camera is so low on the Z axis that it makes it very impractical for viewing initial layers. This clip allows you to put a wyze cam v3 (or v3 pro) on the left side gantry to observe your prints from a higher perspective. The clips snap onto the head of the filament guider and the camera screw hole snaps into the clip to hold in place.
- No supports needed (Prints upside down)
- Non-interference with extruder and filament feeder
- ~2hr print time at 0.1 layer height, 250mm/s and 15% infill (gcode included for PLA+)
- Ribs on support to minimize shaking.
- Weight doesn't affect Z axis.
Print spec
- Formats
- stl
- Model files
- 1
- Total size
- 268.6 KB
- Largest file
- 268.6 KB
0 comments
You may also like 12 models
See all-

-

-

-

-
New -

-
New -

-
New -
New -

-



