
K1 Series - Riser V3 (Sprintech Remix) – Riser cho Creality K1/K1C
Remix of K1 Series - Riser V2 By Sprintech_1983460
- Downloads
- 19
- Likes
- 11
- Views
- 273
- Remixes
- 0
- Comments
- 0
Files 3 19 MB
- Creality_K1C_Riser_remake_with_hinges_v53_Orca_plates_1769833869.3mf3MF · 778.1 KB
- Creality_K1C_Riser_remake_with_hinges_v53_1769833870.stlSTL · 2.8 MB
- Creality_K1C_Riser_remake_with_hinges_1769833870.f3dF3D · 15.4 MB
Make a variant with AI
Build another version of this model.
Details
- Model ID
- #208221
- Category
- Máy In 3D
- Published
Description
I enjoyed this print so much I wanted to do it again and add some upgrades now that I have had some more experience. The one here in the pics is the last test print before I buy a new roll of ASA and do the final print. I liked the contrast so I though I would post these.
When I originally did this, I wanted to have hinges that I could use the K1C lid with. I also wanted to use the side of the lid that has a handle in front so it could be used as a handle. With a bit of faffing, I finally got it right and it works great! The K1C riser did not have a place for the hinges so I did a bit of moving and for those.
Along with the creators great original idea of the push in the hinges I added a push pin in lock. This is because I do quite a bit of TPU printing now, so I wanted the lid to come of easily. I made the pins slightly smaller so the were more lose and the pin lock to keep them in place.
With the lid turned 90 degrees it was also an opportunity to make a slide to cover the opening from the back. This has worked out well, along with the vents in the riser you can open this slide when doing PLA prints etc and it allows you to keep the lid closed but keep plenty of ventilation.
I added a tight hole for the tubing to come out at the back right corner to my filament sensor which is now also movable on a HSW wall.
Lastly I added corner points that screw onto the unit instead of the lose clamps. This has taken the most amount of time to get right.
Again, a BIG thank you to @Sprintech_1983460 This is by far my most favourite mod for my printer and it has allowed me to do so many awesome prints.
If there are any issues with the print or you have any questions please let me know. Happy to help.
Happy Printing.
Print spec
- Formats
- 3mff3dstl
- Model files
- 3
- Total size
- 19 MB
- Largest file
- 15.4 MB
0 comments
You may also like 12 models
See all-

-

-

-
New -
New -
New -

-
New -

-

-

-


