Riser_v2 chỉ dành cho Creality K2Pro dùng kính (Glass)

Please, there is an improved Riser_v2 version for K2 Pro for you.

Corrections:
- increased ventilation area by 50%.
- the design of some facets has been slightly tweaked to closely resemble the design of the K2 Pro.
- the connection tolerance has been corrected from 0.3 to 0.28.
- The connecting horizontal bar has been slightly lowered.

Recommendations:
- use the "Gyroid" filling by 15%.
- Use the "iron" smoothing mode with good settings, this will make the glass surface smooth and safe.
- place the part on the printing table as far away from the side fan as possible, so that there are no traces of air flow, this will have a good effect on the appearance.
- Use the detail border and support in only two places for the dovetail.
- before removing the part from the hot table, be sure to wait for the table to cool down, this will eliminate the deformation of the part and give a good result in separation from the border.
- use a set of fillets for processing the "dovetail" to remove the remnants from the support.
- It is advisable to use plastic glue for the connection, the design will become more reliable.