Deadpool & Woolverine Heart

Project: Deadpool & Wolverine.hfp

Print at 100% infill with a layer height of 0.04mm with a base layer of 0.16mm

 I have added a height range modifier to speed the print up slightly so the layer numbers are different but the mm are the same.

 The Model is 112.54x200mm in size

You may print at higher layer heights below the Base Thickness of 0.48mm
The Max allowed Thickness is 2.24mm and the Actual Thickness is 2.2mm

    #ffd500 PLA+ Sunlu Pure Yellow  Transmission Distance: 5
    #d3b7a7 PLA BambuLab Matte Latte Brown  Transmission Distance: 2
    #9d432c PLA BambuLab Basic Brown  Transmission Distance: 2
    #ff0000 PLA Anycubic Bright Red  Transmission Distance: 5
    #9d2235 PLA BambuLab Basic Maroon Red  Transmission Distance: 1.6
    #b15533 PLA BambuLab Matte Terracotta  Transmission Distance: 1
    #080a0d PLA PolyLite Black  Transmission Distance: 0.3
    #0041cc PLA+ Sunlu Blue  Transmission Distance: 4
    #2e4462 PLA Panchroma Matte Army Blue  Transmission Distance: 0.1
    #ffffff PLA BambuLab Basic Jade White  Transmission Distance: 5
This print uses 10 unique filaments

Swap Instructions:
    Start with Pure Yellow
    At layer #13 (0.64mm) swap to Latte Brown
    At layer #16 (0.76mm) swap to Brown
    At layer #23 (1.04mm) swap to Bright Red
    At layer #24 (1.08mm) swap to Maroon Red
    At layer #27 (1.2mm) swap to Terracotta
    At layer #31 (1.36mm) swap to Black
    At layer #38 (1.64mm) swap to Blue
    At layer #45 (1.92mm) swap to Army Blue
    At layer #47 (2mm) swap to Jade White for the rest