Trò chơi kỹ năng với một quả bóng và đường ray xếp tầng

A simple but fun skill game! Can you get the ball across the cascades to the finish?
This game is easy to print and even easier to assemble.

You will also need:

• 17 screws M3x18 (or slightly longer)
• 15 washers 13x3.3mm (optional)
• 2 screws M3x10
• 2 nuts M3 (hex)
• 2 neodymium disc magnets 10x0.7mm (optional)
• 1 metal ball, diameter approx. 13mm

You can change the filament at a specific layer height to print the numbers and arrows on the rails in a different color. (I have already done that in the provided 3MF-File.)

Use the middle of the three holes to attach the rails with the screws. If the game is too easy or too difficult for you, you can later move the rails to the left or right hole to adjust the level of difficulty. Be careful not to tighten the screws to much. The axes must still be able to move freely.

The two optional disc magnets are used to hold the cup better. Glue one magnet to the bottom of the mug and the other magnet to the mug recess in the base. Pay attention to the correct polarity of the magnets!

Don't forget to post your make and give me a like!

Please check also my Youtube channel: https://www.youtube.com/@BINGOBRICKS