Kệ gia vị xoay (rotatable Spice rack)

Admittedly, the slider is somewhat flexible. It is best to print it from PETG at a minimum.

Insert the slider as shown in the picture.

Push it in until the recess in the groove lines up with the black part here.

Then press the slider onto the lower part.

Next, place a part on top and screw (3x16mm) the main bracket onto it.

The white part can than be clipped together. -after the screws are in!
But not much more than once.
Glue it if necessary to be on the safe side.

Mark the drill holes on the shelf, screw it in place, and its done.

I use one type of spice container for each spice rack width so that things don't slide around so much.