Hũ Lưu Trữ Ma (Ghost Storage Jar)

This is a Large storage pot in the style of a Pac Man Ghost.

You could also use it as a pen pot by not putting the eyes in.

This model prints well, have tried it in 2 filaments (the blue was a bit damp I think hence rough print) and is designed for a tight snap fit, if you find it is too tight I have included a smaller bottom part which isn't so tight.

To test this fit simply cut the very top 5mm of the bottom of the pot off in Orca and test it with the lid - you could do the same with the top of it to test it fits without printing the whole model. When testing let the model cool first.

When inserting the eyes, make sure they are the right way up or the lid won't fit on. The eyes and the pupils are contoured, so make sure you put the right ones in the right holes. It is all snap fit but you could also glue them if you wanted.

I strongly suggest using adaptive layer heigt of 0.3 and smooth about 7 times in Orca Slicer to get the head smooth on the top. I also bridged the top, but you could also use support (I didn't)- you would only need it in the middle of the head, the eye sockets print fine with no support.

Is around 10cm tall.