Khay đựng đồ workshop xếp chồng tham số (Parametric Stackable Workshop Bins)

Perfect little bins for holding stuff and organizing. There are three default variants and the .scad file is fully parametric, so you can customize it for whatever your needs are. The samples in the photos were printed using Polymaker CoPE on fast-draft mode with lightning infill and walls printed inside-to-outside. I recommend using an infill that will reinforce the walls if your model is over ~100mm. You can see the bowing that occurs on tall models if the walls are hollow in the photos.

This model was inspired by, but is not a direct remix of, NullPointer's excellent stackable bins.

Recommended Print Settings

• 0.4mm nozzle
• 0.2mm layer height
• 10% infill
• No supports
• Any filament that isn't flexible
• Print as oriented

Parameters

• insideWidth, insideDepth, insideHeight: Width, depth, and height of the bin (walls are added to these dimensions)
• roundness: Roundness of the corners
• wallThiccness: Thiccness of the walls
• spoutAngle: Angle of the front spout
• spoutHeight: Height of the front spout
• slideStop: Whether you want slide-stoppers or not (these also help support stacking!)
• slideStopRadius: How wide you want the slide-stoppers to be
• slideStopFrontAdjust: If the chosen combination of spout angle/spout height results in the front slide-stoppers floating in the air, you can manually adjust them backward

To customize this model, I highly recommend the excellent OpenSCAD Playground.