Khay Gridfinity 1x1 để nhíp (Gridfinity 1x1 Tweezers Bin)

Overview:

A 1x1 (height 10*7mm) Gridfinity-compatible bin for storing tweezers. The slots for the tweezers are 12 mm x 5 mm, so they should be compatible with a wide variety of soldering tweezers. In particular, they are compatible with Pixnor tweezers and Multicomp Pro tweezers, but they should work for many others.

If you have a magnetic base, then no additional weight should be needed to allow the base to stay down when pulling out the tweezers. If there is no magnetic base, there is a variant of the model that has a space in the bottom for you to put a weight in. In the photo below, I used a two-part epoxy to glue in a 3/8" in hex nut which provides enough weight. 

Print Settings:

The print shown below was done in PETG, with a color change at layer 31 from the top. 

• Prusa MK4 with Grey and Blue filament

• 0.15mm Structural settings

• 15% grid infill

• Paint-on supports only in the weight carveout area

• Filament used: 51.12 g

• Print cost @$23/kg: $1.18 USD