Cánh chắn gió (Vent Flaps) cho Core ONE

Requirements

• 4x M3x8 screws (longer screws should work as well)

Printing

I printed mine using the 0.4mm Obxidian HF Nozzle and the 0.25mm SPEED Preset with Prusament PC CF. While I experienced significant warping for the flaps, this did not affect the functionality.

• Print 4x CoreONE_Vent_Flap
• Print 1x CoreONE_Vent_Frame (NOTE: The STL is upside down)

Installation

1. Clip the flaps into the frame.
2. Ensure they can rotate freely just from their own weight. Depending on the material you used for the print, you might have to sand the rotating part of the flaps, or add a few drops of silicone oil.
3. Mount the frame to the back of the Core ONE.

Inspiration

I liked the Core One Flaps by Miroslav Černý, but was worried the added resistance would reduce the effectivity of the chamber fans. So I decided to create my own chamber vent cover based on the design of traditional dryer vents.