Enclosure Torreva cho Flashforge AD5X (BETA)

PLEASE NOTE: This project is currently considered to be in a "beta" state. No further changes to the main enclosure are expected, but changes are planned for the filter fan unit.

Preview photos (except the first one) may be of older versions of Torreva, or may mix-and-match parts from different versions. The first photo is of an up-to-date build.

PLEASE READ THE DOCUMENTATION BEFORE YOU START YOUR BUILD! It can be found right at the bottom of the Files tab, under the "Other Files" heading.

Torreva is an enclosure for the Flashforge AD5X, designed from scratch rather than based off the official enclosure.

Torreva is significantly more effort to produce than the official enclosure, but the resulting enclosure has considerably better performance in terms of heat retention and noise reduction - and in my opinion, looks nicer too.

Torreva is constructed from a combination of PETG printed parts, and EVA foam panels. All printed parts can be printed on the Flashforge AD5X.

Features:
- Very good heat retention (capable of reaching over 50°c in under an hour heated solely by the bed)
- Easily removable front door, with two different options (EVA or acrylic)
- Hinged lid with latches
- IFS tube cover
- Carbon filtration unit for ABS / ASA / etc fumes
- Attempted accomodations for the Flashforge camera; how well they will work depends exactly how long your cable is (it's very tight)
- Customization-ready nameplate

Torreva is licenced under the Open Community Licence. This means you cannot sell it, but you are welcome to produce it for your own use, including your own internal commercial use, free of charge. I am not considering commercial licencing and/or accepting donations at this point in time, but may think about these things once it's out of beta.

---

Update changelog (all timestamps are UTC and rounded to 15 minutes)

As of V0.20, instructions to upgrade between releases are now in the documentation instead of here. 

(V0.31) 2026-01-27 09:45 - Completely overhauled the documentation; most of it is rewritten from scratch. New documentation has some differences in recommended screw sizes. No changes to any printed parts.

(V0.30) 2026-01-20 12:45 - Changed magnets in FR-0, FR-1, D-xx-TR and D-xx-BR to 8x2mm instead of 5x2mm; slightly reduced length of screen clip protrusion in FR-1; added some extra screw holes (intended for a USB hub mount or similar) to FR-2 and moved the pass-through hole for the fan cables to the side; slightly enlarged all screw thread / hex nut holes that print facing upwards or downwards to make them less difficult.

(V0.21) 2026-01-17 12:00 - Fixed incorrect labels on BR-2 and BR-3.

(V0.20) 2026-01-14 13:45 - Reduced the height of the top-tier pieces (FL-3, FR-3, etc), and modified IFS-Cover accordingly. Modified BR-1 and BR-2 so that the print head cable no longer needs to be disconnected to install or remove these pieces. Added identifying labels to most pieces.

(V0.13) 2026-01-13 12:00 - Added a variant of the nameplate (now the one included by default in the 3MF file) with the text "AD5X". Documentation tweaks; some tweaks to nameplate filenames.

(V0.12) 2026-01-13 06:00 - Modified the lid latch pieces (L-Latch-Pin and L-Latch-Cover) to look nicer and extend out a bit further. Also made some slight changes to the documentation.

(V0.11) 2026-01-12 09:30 - Updated documentation to add a photo of my Torreva build on the front page. No other changes.

(V0.10) - Initial public beta release.