
Bài Test Hiệu Chuẩn & Stress Hình Sói (Wolf Calibration & Stress Test)
- Downloads
- 203
- Likes
- 17
- Views
- 429
- Remixes
- 0
- Comments
- 0
Files 1 15.9 MB
- Wolf_Calibration_Stress_Test_1769445616.3mf3MF · 15.9 MB
Make a variant with AI
Build another version of this model.
Description
A compact sitting wolf figure designed specifically for testing FDM printer capabilities. At 5 cm tall, it prints fast enough for regular calibration checks while providing meaningful feedback on your printer's performance.
The model combines a recognizable shape with practical test features. The geometry challenges common printer weaknesses—overhangs, layer consistency, surface finish—while staying printable without supports on most machines.
What it tests:
-
Aggressive overhang angles (tail approaching 90°, snout around 80°, body segments)
-
Layer adhesion and Z-axis accuracy through the segmented body and neck
-
Surface finish on curves and angled surfaces
-
Fine detail capture (facial features, fur texture)
-
Overall dimensional accuracy
-
First layer adhesion with the flat paw base
Print specs:
-
50mm tall
-
Uses approximately 9 grams of filament
-
Print time: 30-40 minutes (depending on settings and printer)
-
Single piece, no assembly
-
Prints without supports
-
Works with 0.4mm nozzles and typical layer heights
Recommended use: Try it when testing new filament, after making printer adjustments, or when dialing in a new material profile. PLA gives the cleanest results for detail evaluation. PETG is useful for checking stringing and cooling performance. The model works across most standard FDM setups.
Good as a functional test piece that doesn't look like a test piece when you're done.
Print spec
- Formats
- 3mf
- Model files
- 1
- Total size
- 15.9 MB
- Largest file
- 15.9 MB












