Hộp (box) DJI Mini 2 / Mini 2 SE

DJI mini 2 Case with 3x Micro SD card slots, extra prop slot, and spare storage under the drone and batteries via a compartment accessible through the controller slot.

Printed in PETG, 5% Gyroid infill, 0.25mm layer height for the main body.

I would probably do a 10% to 15% infill for the lid and latches.

Uses M3 screw hardware for latches and hinges.

Battery levels for the battery holder are also viewable if the prop slot is empty or cleared enough.

I also shortened the box to make it shorter compared to the original to save on material, and lowered the height by about 20mm or so. There should be about 3 layers from the bottom to the outermost part of the bottom of the drone controller. It is very secure still, and has no significant flex on the bottom with a 5% gyroid infill. The lid is more questionable, as it flexes more, but overall, the lid is still pretty good and rugged. (I did not make the lid thinner.) I did print the lid with the Prusa mini file, and the body with the MKS file, but they should both fit on either printer.