Skip to main content
F3D
Passthrough bao vây Prusa Prusa 1
Passthrough bao vây Prusa Prusa 1
1 / 4

4 images

Máy In 3D

Passthrough bao vây Prusa Prusa

By MiroJ_57514

Remixes
2
Download all (.zip)· 2 files · 1.2 MB· 1.2 MB

Files 2 1.2 MB

  • Prusa_OrgEnclosure_PassThhrough_0.15mm_PLA_MK3S_22m_1766603978.gcodeGCODE · 552.5 KB
  • Prusa_OrgEnclosure_PassThhrough_1766603977.stlSTL · 641.9 KB

Make a variant with AI

Build another version of this model.

Open Studio

Remix versions 2

See all 2 remixes

Details

Model ID
#20067
Category
Máy In 3D
Published

Description

The bowden fitting is very firm, you might need to use players to push it in. If your print tolerances are a bit off. Use a 4mm drill to remove the excess from the print walls for the bowden fitting.

  • Print it flat with no support.
  • Reuse the nylon rivets.
  • You will need about 45 - 50 cm long bowden tube.
  • print it as 0.15mm layer height it will take about 20 minutes.

I have printed this in PLA however any other material can be used.

Read more Show less

Print spec

Formats
gcodestl
Model files
2
Total size
1.2 MB
Largest file
641.9 KB

0 comments

See all

F3D uses essential cookies so the site works. Accept all also turns on marketing cookies for traffic and ad measurement; Essential only does not. You can change this in Cookie settings. Read the cookie policy