
Spacer thay thế cho Ikea Skadis (Ikea Skadis Replacement Spacer)
- Downloads
- 10
- Likes
- 2
- Views
- 90
- Remixes
- 0
- Comments
- 0
Files 2 5.5 MB
- ikea_skadis_spacer_1768172762.stlSTL · 5 MB
- printable_washer_1768172763.stlSTL · 562.6 KB
Make a variant with AI
Build another version of this model.
Details
- Model ID
- #200604
- Category
- DIY
- Published
Description
This is a printable version of the Ikea Skadis spacer for the Ikea Skadis pegboard. It has the same dimensions and works as a direct replacement of the original spacer. The design is slightly improved. The 2 pins are enlarged to prevent them from breaking easily. The pin size on some other designs weren't sufficient and snapped off when installing. The maximum possible screw length is also slightly improved over the original.
It fits the original screw that came with the pegboard as well as M4 screws up to 20mm.
There is a model for a printable washer in case you don't have one at hand. A normal washer can be used too of course.
Recommended Print Settings
-
Tested with PLA/PETG (Ideally PETG, but it will work with PLA as well.)
-
0.15mm layer height
-
3 Perimeters
-
20% infill
Print spec
- Formats
- stl
- Model files
- 2
- Total size
- 5.5 MB
- Largest file
- 5 MB
0 comments
You may also like 12 models
See all-

-
New -

-

-

-

-

-

-

-

-

-


