Skip to main content
F3D
Bora Centipede X-Cups vặn ốc (giá đỡ 2x4) - Screw-Together 1
Bora Centipede X-Cups vặn ốc (giá đỡ 2x4) - Screw-Together 1
1 / 5

5 images

DIY

Bora Centipede X-Cups vặn ốc (giá đỡ 2x4) - Screw-Together

By EdYu

Downloads
2
Likes
1
Views
68
Download all (.zip)· 4 files · 507.3 KB· 507.3 KB

Files 4 507.3 KB

  • tolerance-test-female_1768163230.stlSTL · 69.2 KB
  • tolerance-test-male_1768163231.stlSTL · 82.7 KB
  • xcup-pin_1768163231.stlSTL · 122.9 KB
  • xcup-support_1768163232.stlSTL · 232.4 KB

Make a variant with AI

Build another version of this model.

Open Studio

Details

Model ID
#200554
Category
DIY
Published

Description

Was hesitant about making these since I figured layer lines in this flat orientation might cause frequent breaks of the risers. After printing, however, they feel pretty solid. Time will tell I guess.

Results may vary for you since I've tested this with ABS with a 0.6mm nozzle.

The cylinder screws into the bracket itself. It is meant to be permanent, with tight tolerance, and likely requires pliers to screw in.

This printed without supports/brims just fine for me in about an hour.

Read more Show less

Print spec

Formats
stl
Model files
4
Total size
507.3 KB
Largest file
232.4 KB

0 comments

See all

F3D uses essential cookies so the site works. Accept all also turns on marketing cookies for traffic and ad measurement; Essential only does not. You can change this in Cookie settings. Read the cookie policy