Mod khay để ly Volvo P1 (S40/C30/V50)

I had an empty box in my car and needed Cup Holders. However these can't be obtained new anymore and there are versions that are too shallow to hold a 330ml or 250ml can. So i made one that supports 330ml and one with both 330 and 250ml. 

I made the holders with PLA and the top with PETG (to stand hot summers). I suggest you make it with PETG altogether. The top I made face down on a textured sheet so it looks nicer. Then glued it together with superglue.

I suggest you use the 330ml Cup if you drink different kind of beverages. It fits best for all kinds of drinks.

There is also a full model with one 330ml and one 330/250ml holder. However this requires alot of support.

You might need to remove the rubber in the bottom.