
Hệ nắp cover nam châm cho Core One, tương thích AUTO-VENT
- Downloads
- 1
- Likes
- 1
- Views
- 105
- Remixes
- 0
- Comments
- 0
Files 3 763.6 KB
- Prusa_Core_One_magnetic_cover_rear_1767938341.stlSTL · 14.3 KB
- Prusa_Core_One_magnetic_top_cover_front_handle_1767938342.stlSTL · 19 KB
- Prusa_Core_One_magnetic_top_cover_0.4n_0.2mm_PETG_COREONE_1h23m_1767938342.bgcodeBGCODE · 730.2 KB
Make a variant with AI
Build another version of this model.
Details
- Model ID
- #198502
- Category
- Máy In 3D
- Published
Description
This simple cover design doesn't require any large surrounds or screws, and doesn't interfere with the automatic vent opening feature of the Prusa Core One+.
The handle and rear plate require 16 20x5x2mm neodymium magnets, though I've designed it to work with 20x6x2, or either size up to 4mm thick. You can use fewer magnets, but it won't hold as strongly. I used these: https://www.amazon.co.uk/dp/B0DG2NLST2?th=1
You'll also need some strong, thin double-sided tape (not foam tape as that's too thick). I used some that I had kicking about but have no idea where to buy it, so if anyone knows, please do let me know.
Print the parts top-down, ideally in Prusament Galaxy Black for a factory finish that matches the metalwork. Drop the magnets in, lay the tape over the top between the two pegs, then them stick onto the front and back of the cover, using the pegs to locate into the rivet holes for accurate positioning.
I wanted a more elegant design than the ones I'd seen, and if you take the cover off for easier servicing of the Nextruder (or to allow more air in), the cover can be attached to the left side of the printer for safe and easy storage.
Print spec
- Formats
- bgcodestl
- Model files
- 3
- Total size
- 763.6 KB
- Largest file
- 730.2 KB
0 comments
You may also like 12 models
See all-

-

-
New -
New -
New -
New -
New -

-

-

-

-


