
Giá Treo Tường Katana (Katana Wall Mount)
- Downloads
- 2
- Likes
- 1
- Views
- 81
- Remixes
- 0
- Comments
- 0
Files 2 1.7 MB
- Katana_Wall_Mount_1767902248.3mf3MF · 1.5 MB
- Katana_Wall_Mount_1767902248.stepSTEP · 116.9 KB
Make a variant with AI
Build another version of this model.
Details
- Model ID
- #197189
- Category
- DIY
- Published
Description
There are a few holders for your katana out there, but I didn't really like any of them. Some of them use too much filament, some separate the blade and the saya too much, in others they are too close...
So I made this model:
-
It is as minimal as I could made it, so the katana is the main focus
-
I find the separation between blade and saya to be in the goldilocks zone, but you can easily modify the step file
-
The screws are covered by the blade
-
The holders themselves are a few mm wider so you can put some EVA foam and prevent the plastic from sratching the blade
-
Used 6mm wall plug
Mirror the model in the slicer so the good surfaces are opposite to each other.
Print spec
- Formats
- 3mfstep
- Model files
- 2
- Total size
- 1.7 MB
- Largest file
- 1.5 MB
0 comments
You may also like 12 models
See all-

-

-

-

-

-

-

-

-

-

-

-
New

