Philips Hue Nút thông minh Shelly chèn

I replaced my light switches with Shelly Wall Switches in order to control my ceiling lights and additional automation.

I use Philips Hue Smart Buttons for each room as triggers for boost-cycles of my Thermostats.

To prevent ripping the wallpaper apart with tape or drilling right above a lightswitch where cables run, I decided to create an insert for the dual frames from Shelly Wallframes.

This model is designed to work only with Shelly Frames and is just a holder that requires a 5x5mm cube-magnet to hold the button. It does not provide any power. This is just a replacement for the original wallplate from Philips so you don't need to hack down yours.

Printing is easily done and should work with any settings.

Used my Ender 3 S1 Pro with 0.4mm Nozzle.

Settings:

0.2mm Layer Height

0.4mm Wall thickness

10% Infill

Printed this in roughly 35minutes with my Sonic Pad.