Hỗ trợ thẻ đồ họa

Graphics cards are getting heavier and heavier. This is a screw/post type of support for cases with no provision for it.

To assemble, first screw the nut down the main part/base, then slide the central post in.

Extend the central post by screwing and unscrewing the nut. In case its too hard to get the nut to screw in for the first time, print the cylinder guide, place it on the screw and then slide the nut over.

The thin part with the same shape as the top of the central post can be printed with TPU and act like a cushion for the card being supported.

Effective height: ~88mm up to about 140mm

If you liked this thing enough (and was hopefully useful!), please consider supporting me via Paypal in doing more stuff like this! https://www.paypal.com/donate?business=XH9JMVWXCULKS&currency_code=EUR