Torch-Taser Belter bao da

Multipart belt holster I modeled for a friend. It have space for torch-taser combo(Police 80000W), DEWALT folding pocket knife (DWHT10313) and carabine utility blade knife.

Belt parts are held together by 4x M3x20 screws, you also may be forced to file the belt clip - lock's “thorn” to make sure it open/close without issue.

Belt clip supports up to 60mm tall belts, with spacer for shorter ones(goes in increments of 10 mm, using screw holes). Maximum thickness of the belt is 5mm.

Holster have spaces for:

8x M4 heat set inserts - for the belt clip (with M4x8 screws, I'd recommend button head screws)

7x M3 heat set inserts - for addons (with M3x10 screws)

Velcro strip holding torch - up to 13mm tall

1x M3x6 screw holding Velcro strip from sliding out, I'd recommend button head screw

I also used 2mm thick foam on the bottom of the torch pocket and on the fulcrum at the top, to stop torch from rattling while moving.

Knife addon and utility blade magnetic holder use 6x4mm cylinder neodymium magnet pressfitted into the respective holes, to hold them in place when moving. For knife addon I'd recommend button head screws.