RPG-7 cho Dummy 13 / Lucky 13

From the depths of Russia.
No-frills gun. The very definition of frugal power, recommended by ten out of ten Mujaheddins. Delivering explosives for hundreds of meters with 'just enough' accuracy for more than 50 years. And now it can be yours. The RPG-7.
 ---------

So. After finishing my minigun and the MAAWS, I realized that Dummy 13 was missing one of the most iconic weapons of the last few decades (at least in the detail it deserves). So, I fashioned one. I hope you'll like it. 

Printing instructions:

• Everything is set in .3MF project file - including custom enforced support regions, custom painted seams and some other slicer settings. Just download the project file, choose your printer&filament and you are ready to go
• There is a cooling tower printed with the model. Do not remove it,  or the print fails.
• 0,2mm or 0,15 mm layer height, at least 3 perimeters, supports needed. Classic perimeter generator gives slightly better results (regarding the scope) than now-default “arachne”. 
• The sights are designed with trimming in mind. After you print them, cut off these three or four curled layers, before they make nice straight “eye” acting as reticle

Disclaimer:

The model is tailored to be printed in 100% size with 0,2 mm layer height. Succesfully printed with 0,1 mm layer height too, but I am not sure, how well it resizes (some parts will bee noticeably “too beefy” when scaled up).  

Printed in Filament PM Ranger Grey PLA+ with some parts painted black (using permanent marker). 

Inspiration taken:

• https://en.wikipedia.org/wiki/RPG-7
• http://www.rusmilitary.com/html/deact_rpg7.htm
• https://www.guns.com/news/2014/04/26/the-rpg-7-grenade-launcher-not-lost-in-translation
• https://russianoptics.net/PGO.html

Changelog:

2025-09-22 version 1.4 uploaded, slight change in iron sights (more narrow housing, added locking knob)