
Elegoo Centauri Carbon active chamber với Creality Chamber Heater
- Downloads
- 41
- Likes
- 23
- Views
- 568
- Remixes
- 2
- Comments
- 0
Files 10 29.7 MB
- Ring_1767398455.stpSTP · 220.8 KB
- Ramp_1767398456.stpSTP · 85.8 KB
- Hat_1767398457.stpSTP · 190.1 KB
- Stub_1767398458.stpSTP · 27.7 KB
Make a variant with AI
Build another version of this model.
Remix versions 2
Ngàm gắn điều khiển Creality Chamber Heater cho Centauri CarbonBypeterforster_3653860 · 03/05/2026
Bộ Template Hỗ Trợ Heater Creality cho Centauri CarbonBytbrymer_796273 · 01/03/2026
Details
- Model ID
- #190102
- Category
- Máy In 3D
- Published
Description
Хочу поделиться с вами моделями, которые я делал в ходе модернизации своего принтера Elegoo Centauri Carbon, чтобы получить активную камеру.
Всего это 5 файлов:
Фиксация проводов для вывода их из камеры (2 файла), рампа для циркуляции теплого воздуха, крышка защищающая обогреватель от случайных кусков пластика и пыли, и магнитное крепление дисплея обогревателя.
Я использовал неодимовые магниты 5Х10 мм. Всего потребовалось 6 шт. 3 шт на рампу и 3 на крепление дисплея. Чтобы поместить их в модель нужно печатать через паузу.
Для того, чтобы продеть провод в отверстие для держателя катушки придется разобрать обогреватель и отсоединить шлейф пульта управления. Сам обогреватель я закрепил комплектными винтами к стенке принтера.
I want to share with you the models that I made during the modernization of my Elegoo Centauri Carbon printer in order to get an active chamber.
There are 5 files in total:
Fixing the wires to remove them from the chamber (2 files), a ramp for warm air circulation, a cover that protects the heater from accidental pieces of plastic and dust, and a magnetic mount for the heater display.
I used 5X10 mm neodymium magnets. In total, it took 6 pcs. 3 pcs for the ramp and 3 for the display mount. To put them in the model, you need to type after a pause.
In order to thread the wire through the hole for the coil holder, you will have to disassemble the heater and disconnect the cable of the control panel. I fixed the heater itself with complete screws to the wall of the printer.
Print spec
- Formats
- stlstp
- Model files
- 10
- Total size
- 29.7 MB
- Largest file
- 10.4 MB
0 comments
You may also like 12 models
See all-

-

-

-
New -
New -
New -

-

-

-

-

-


