
Large file collection Đồ Gia Dụng
Bộ Núm Tay Nắm Cửa Pokemon Low-Poly
Remix of Cyndaquil phong cách low-poly cho in 3D By flowalistik
- Downloads
- 969
- Likes
- 328
- Views
- 8,253
- Remixes
- 0
- Comments
- 0
Files 24 75.9 MB
- pikachu_1gen_flowalistik_M5_knob_1767385492.stlSTL · 244.4 KB
- squirtle_starter_1gen_flowalistik_M5_knob_1767385493.stlSTL · 437.9 KB
- bulbasaur_starter_1gen_flowalistik_M5_knob_1767385494.stlSTL · 185.5 KB
- charmander_starter_1gen_flowalistik_M5_knob_1767385495.stlSTL · 254.7 KB
Make a variant with AI
Build another version of this model.
Details
- Model ID
- #188612
- Category
- Đồ Gia Dụng
- Published
- Tags
- wall
- wallmount
- hook
- pokemon
- door
- handle
- lowpoly
- drawer
- knob
- wallmounted
- hooks
- wallhook
- pikachu
- wallhanger
- drawers
- towelhook
- doorhandle
- pokemonfigures
- knobs
- coathook
- pokemons
- bulbasaur
- charmander
- squirtle
- pokemonfigure
- gengar
- eevee
- clotheshook
- drawerhandle
- doorknob
- mew
- cyndaquil
- drawerknob
- totodile
- lapras
- lowpolypokemon
- lowpolypikachu
- clefairy
Description
Wanted some pokemon door knob for the kids room drawers. It didn't exist, now it does.
Some of them could definitely be used as hooks too !
How to print:
- Print with bottom/face of the knob facing down, that is the the only way to insert the M5 nut mid-print. (See gcode)
- A minimum of 3 perimeters if you are going to use it as a knob. Mine are in the kid's bedroom, I went for 5 perimeters.
- Add color swap or pause just before the M5 inner chamber start to close. See pictures and/or gcodes.
- During print, when the color swap happens, drop the M5 in its chamber. See picture. Make sure it is all the way down and can be touch by the nozzle.
- Unfortunately support are required for almost all knobs. I tried various workflows but here is the one that was the fastest and provided OK-ish results: use the paint support tool to highlight all face with overhang superior @45° then, enforce only the critical one with the smartfill selector, one by one**.** There might be a better way of doing it, when I use the automatic tool the M5 chamber got filled with support.
Edit 30/08/2022: I made some card holder to display the card on the side of the knob. My kid like it! (see picture) :https://www.printables.com/model/268683-card-holder-vertical-wall-display-poker-size-pokem
Hope it helps !
Print spec
- Formats
- gcodestl
- Model files
- 24
- Total size
- 75.9 MB
- Largest file
- 8.6 MB
0 comments
You may also like 12 models
See all-

-
New -

-

-

-

-

-

-

-

-

-
New

