Đứng dây tóc nhỏ

I tried a different filament spool holder and I didn't love it. This one I printed with 10 percent hexagon infill and it flexes just enough to do what I intended. Have to flex it open to get the spool in and then run a ¾ 10 bolt through it and secure it with a nut and just tighten the stand a bit so the spool spins nicely. To remove just pry open the stand a bit and push the filament out. Just takes a little figuring out but once you figure it out it is pretty easy. Bolts and Nut are printing now so I have no photos available yet.