
RatRig Toolhead V1 Beta2 Bộ cắt sợi
- Downloads
- 115
- Likes
- 22
- Views
- 1,731
- Remixes
- 0
- Comments
- 0
Files 8 83.6 MB
- rr_toolhead_v1_beta2_cutter_mod_carriage_spacer.stlSTL · 95.2 KB
- rr_toolhead_v1_beta2_cutter_mod_blade_mount.stlSTL · 110.2 KB
- rr_toolhead_v1_beta2_cutter_mod_servo_mount_enc2.stlSTL · 5.9 MB
- rr_toolhead_v1_beta2_cutter_mod_back.stlSTL · 4.6 MB
Make a variant with AI
Build another version of this model.
Details
- Model ID
- #186935
- Category
- Máy In 3D
- Published
Description
There is a version for the V1 version of this toohead found here: https://www.printables.com/model/1088377-ratrig-toolhead-v1-with-filament-cutter
There is also a version for the v3.1 toolhead v1 upgrade found here: https://www.printables.com/model/1146395-filament-cutter-for-ratrig-toohead-v1-vcore31-upgr
This is a filament cutter for the beta2 ratrig toolhead. Please see my eva3 filament cutter for more details and important info and setup info: https://www.printables.com/model/647352-filament-cutter-for-eva3-orbiter-rapido
Except use a 3mm x 15 compression spring like this: https://www.amazon.com/uxcell-Compression-Stainless-Compressed-Capacity/dp/B08VF311YS/ref=sr_1_9?
For the lever, use a 3mm x 20mm long socket head set screw, a 3mm heat set, and loctite.
Much of the hardware that comes down from the top machined metal plate has to get 5mm longer because the metal plate (and everything above it) was raised 5mm up to allow room for the cutter assembly. This would be any screws that must pass through and secure other parts below the metal, but not screws that are used to secure items that only hold parts above the metal plate. For example the orbiter2 mounting screws do not need to get longer, but the screws that connect the top to the carriage (through the new spacer print) must get 5mm longer. Refer to the .stp file to look at hardware lengths.
Print spec
- Formats
- stlstp
- Model files
- 8
- Total size
- 83.6 MB
- Largest file
- 61.2 MB
0 comments
You may also like 12 models
See all-

-

-

-
New -
New -
New -
New -

-

-

-

-


