Skip to main content
F3D
Mô hình Pokeball Cherish Ball 1

2 images

Cosplay

Mô hình Pokeball Cherish Ball

Remix of Pokeball với cơ chế bản lề in liền và khóa từ By yoyothechicken

By yoyothechicken

Downloads
173
Likes
37
Views
827

Files 12 6.4 MB

  • Cherish Ball Rings Loose.stlSTL · 415.5 KB
  • Cherish Ball Rings Tight.stlSTL · 415.3 KB
  • Cherish Ring 1.stlSTL · 406.8 KB
  • Cherish Ring 2.stlSTL · 397.8 KB

Make a variant with AI

Build another version of this model.

Open Studio

Details

Model ID
#186352
Category
Cosplay
Published

Description

A Cherish Ball, based on my original pokeball model. This model is listed as a remix because due to the new ring geometry and alignment pin locations, these lid and ring parts are not compatible with the originals.

Misc. Info:

  • The print-in-place ring mechanism has two versions with different tolerances. Make sure your elephants foot compensation is set properly to prevent the hinge from seizing.
    • The loose (original) version has a minimum gap size of 0.3mm, and should work with most printers
    • The tight version has a minimum gap size of 0.2mm, and should only be printed if you are confident with your printer's capabilities
  • The magnets I used measure 6mm x 1.75mm (6x2 nominal). I got them from amazon: https://www.amazon.com/gp/product/B07KJ9H31P
  • Printable alignment pins are included, but you can use machined pins too
  • This model will need some painting or multi-material printing to add full color

Assembly Instructions: 

Refer to https://www.printables.com/model/687259-pokeball

Read more Show less

Print spec

Formats
3mfstl
Model files
12
Total size
6.4 MB
Largest file
1.8 MB

0 comments

See all