Giá đỡ cốc đôi Suzuki Jimny

IMPORTANT: If you aren't at least 6", preferably 6"2, this is not for you.
Or if you drive like Fast and Furious, that will do.

It was designed based on my height and how far back my seat is, the design is as it is.

NON COMMERCIAL USE: I will keep an eye on this.

4L GEAR: Some folks who bought similar cup holder, have mentioned about problems to engage the 4L gear, this is not a problem with this design.
I took that into consideration, the walls aren't as tall and I can fully engage 4L without issues compared with the ones from Amazon.

The cups were designed to fit a 2mm foam sheet to avoid noise. 
It is optional but it is there.

I used ASA-CF, avoid using anything below ABS or it will warp with heat.
PLA is a big no and although PETG has lower melting point than ABS, it resists better against UV/weather than ABS.
 

This is just a peace of mind since half of this cup holder will be resting in nothing.
It sits on the rail, they are attached together with velcro: 2mm
The part touching the rail, has a small rubber to avoid noise: 1mm clearance on each side and top.

This also gives you an idea how far back is my seat.