Giá đỡ ADT-Link UT3G USB4 eGPU + SFX

Prints without supports upside-down, is compatible with 3 slot GPUs and you can cut off some hight in the slicer, if you have more compact cables

Assembly

1. Plug the GPU into the adapter
2. Insert the middle (M2) rod and attach it with a washer and M3x16 screw from the bottom
3. Screw in the thumb screw on the bracket
4. Screw in 2 additional M3x16 screws with washers to the adapter for stability and secure them with a nut from the other side
5. Screw in the PSU with the intake facing away from the GPU - the screws should be just long enough

After printing it, I saw 2 problems and have made some adjustments, but didn't reprint yet: The hole for the thumb screw was not properly aligned and it was a bit loose, so I have added a small extrusion on that side as well