Cốc Bia / Cốc Nước Ngọt

Keep your drink cool and covered and avoid spilling with the Beer Buddy. 

Features

• Vintage tankard styling with an embossed lion 
• Large handle
• Widened base to resist tipping
• A flip top cover to keep bugs away from your drink
• Designed for North American and European beverage cans

Two lid types are provided.  The North American lid will sit level to cover a North American 12 oz beverage can.  The European lid will sit level to cover a European 330ml beverage can.

Slicer Settings (Cura)

Mug: 

• Orientation - sitting on the bottom of the mug
• Layer height - 0.28
• Wall line count - 2
• Top layers - 4
• Bottom layers - 4 (increase for a heavier base)
• Infill density - 15%
• Infill pattern - lines
• Support - Required
• Support Placement - Everywhere

Lid: 

• Orientation - open part away from bed; lid is upside down
• Layer height - 0.28
• Wall line count - 2 
• Top layers - 4
• Bottom layers - 4
• Infill density - 25% (more if you prefer a heavier lid)
• Infill pattern - lines
• Support - Required
• Support Placement - Everywhere

Pivot Pin: 

• Orientation - Laying on its side so the layer lines cross the pivot point
• Layer height - 0.20
• Wall line count - 99
• Build plate adhesion - Brim but you might not need it 

Assembly:

• You may need to whittle or sand down the pivot pin slightly if it fits tight or use a small file to make sure that the pivot pin openings are actually round.  Do not force the pin into the lid opening or a pivot pin opening may crack. 
• Insert lid into top of mug with opening towards bottom of the mug
• Insert pivot pin through the mug lid anchor and lid.
• If the pivot pin fits snuggly then you are finished otherwise follow the next step.
• There is a small hole in the lid pivot area under the thumb tab.  After the pivot pin is in place, either use a dab of superglue to hold the pivot pin in place, or if you'd like the option of removing the lid later, use a tiny sheet metal screw (M2.2) to secure the pivot pin.