
Vòng Ch chừa Cuộn Giấy Elegoo Cho Hệ Thống AMS Bambu Lab
Remix of Bộ chuyển đổi cuộn filament Elegoo cho Bambulab AMS By Harnik3d
- Downloads
- 3,891
- Likes
- 349
- Views
- 14,008
- Remixes
- 1
- Comments
- 0
Files 13 176.2 MB
- elegoo_bambu_spool_adapter_Latest_For_Smaller_Roll_1767052371.stlSTL · 25.8 MB
- elegoo_bambu_spool_adapter_Latest_For_Smaller_Roll_1767052373.3mf3MF · 7.8 MB
- elegoo_bambu_spool_adapter_Latest_For_Smaller_Roll_1767052374.stepSTEP · 583.1 KB
- elegoo_bambu_spool_adapter_modified_v50_SLIM_SHORT_STUDS_1767052375.stepSTEP · 411 KB
Make a variant with AI
Build another version of this model.
Remix versions 1
See all 1 remixDetails
- Model ID
- #183301
- Category
- Máy In 3D
- Published
Description
Use Arachne wall generator or your walls till be too thin and split.
If you have issues with the ring being too tight on the spool, you should print the test print I included to measure the hole and contour accuracy of your printer/slicer. You may need to print the test print I included, and then you can adjust your Hole and Contour X-Y compensation. I set both the Hole and Contour compensation to 0.1mm which is true to size for my machine.
The original ring was too large and would not allow the AMS lid to close, so I reduced the diameter so it would fit. The AMS system only accepts 190mm - 202mm in diameter, so it was 1mm big. I also noticed the studs were slightly off and was pressing against the cardboard spool holes. Additionally, I added a small lip on the outer ring so it will snap into place as you run your thumbs around the outer edge.
Print spec
- Formats
- 3mfstepstl
- Model files
- 13
- Total size
- 176.2 MB
- Largest file
- 41.6 MB
0 comments
You may also like 12 models
See all-

-

-

-

-
New -
New -
New -

-

-
New -

-



